4 posts shown.
Since my smart plug decided to go on strike, I'm basically just following the manual at this point.
Thanks, George Murphy12, I'll check that out.
Set your 2.4 GHz Wi-Fi network to these specific settings:
Channel 10 (or anything lower), with the bandwidth set to either 40 MHz or 20 MHz—whichever one you can actually find in your menu.
Make sure DHCP is toggled on.
You’ll need to disable smart lighting controls and any strip management features.
WMM, APSD, and any other power-saving modes have to be switched off.
And don't use Cloudflare for your DNS—I honestly have no clue where to even look for that setting.
The 2.4 GHz band should be on 802.11g, though my router only gives me the option for 802.11 b+g.
I've been digging through these instructions for ages.
Thanks for the hand, though my grasp of English isn't exactly Ivy League level, so some of this is still flying a bit over my head.
I’ve got my Speedport Plus modem set up, but this is where my technical expertise hits a brick wall. I was handed these specific instructions to follow:
For the 2.4 GHz Wi-Fi band, set it to 802.11g. Use Channel 10 (or anything lower). Set the bandwidth to either 40 MHz or 20 MHz. DHCP needs to be toggled on. Make sure smart lighting and beamforming are both disabled. You also have to turn off WMM, APSD, or any other power-saving modes within the router settings. Lastly, don't use Cloudflare (DNS).
Please, anyone, help me out here.